Enduro Computer Mount
- Regular Price
- Sale Price
- Regular Price
- Unit Price
Sticks Like $%*? To a Blanket!
Self-adhesive computer mount using 3M VHB tape (very high bond)
Designed to fit onto your top tube behind your stem for maximum protection and less distraction.
Please note that some customers have been suprised that the Type A has a pronounced curve to the base, be assured that it will flex to flat. Type A has a single dot on the spine.
Flat for flat top tubes with a minimum of 26mm wide flat area.
NEW COLOUR OPTIONS
Currently available for Garmin Type A only
Our colour options are Cerakote coatings. Cerakote is a ultra thin ceramic coating which is hydrophobic, chemical and scratch resistant.
Top left to bottom right in image:
Blue Titanium (metallic flecks)
Tequila Sunrise (metallic flecks)
Burt Bronze (metallic flecks)
Firehouse Red (satin)
Magenta (flat matte)
Testing has shown that the coating on the enduro mounts are resistant to wear, however the tip of the little Garmin engagement tabs ( at 3 and 9 o'clock) will wear down to black.
Supplied with alcohol wipe to clean the area to be attached to.
Manufactured in-house using our Multi Jet Fusion industrial 3D printer then shot peened for surface toughness and quality.
After fitting the mount should be left overnight before riding, this ensure the adhesive has cured.
See videos in image section of install and uninstall instructions. Also available here.
Recommended for smaller series computers no larger than Wahoo Element Roam, Garmin 500 series. Larger computer are vunerable to knee knocks. As with any mount we recommend loopin
IMPORTANT - Check there is clearance from the underside of bars/stem to the top tube. SEE CLEARANCE DIAGRAM
Sticks to Invisframe, Dyed Bro, and AMS frame protection - others not tested.
To remove pry the mount off from one end. The adhesive pad should remain in one piece but cannot be reused. Replacement VHB pads are available here. It helps to heat with a hairdryer or leave in a warm room beforehand.